 
| Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0v7hUm-0000QlC; Mon, 30 Sep 96 07:30 CDT |
| Old-Return-Path: |
|
| Date: |
Mon, 30 Sep 1996 08:30:34 -0400 |
| Precedence: |
list |
| X-Sun-Charset: |
US-ASCII |
| Resent-Sender: |
|
| X-Status: |
|
| Status: |
O |
| X-Mailing-List: |
|
| TO: |
|
| Return-Path: |
<TechNet-request> |
| X-Loop: |
|
| Resent-Message-ID: |
<"Wu1h7.0.KHH.qrxJo"@ipc> |
| Subject: |
|
| From: |
|
| From [log in to unmask] Mon Sep 30 11: |
10:51 1996 |
| Resent-From: |
|
| Cc: |
|
| Message-Id: |
|
| Parts/Attachments: |
|
|
Juan...
We use the same tooling hole parameters for all
products. The holes are located with respect to each
other with a tolerence of +/- .003 and the finished
non-plated hole tolerence is +/- .001. Works for us.
Hope this helps.
Regards,
Bob Vanech
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|
