Juan...
        We use the same tooling hole parameters for all
   products. The holes are located with respect to each 
   other with a tolerence of +/- .003 and the finished 
   non-plated hole tolerence is +/- .001. Works for us.
   Hope this helps.

                                   Regards,
                                           Bob Vanech

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************