Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0wtBZf-000Bj9C; Tue, 29 Jul 97 07:40 CDT |
Old-Return-Path: |
|
Date: |
Tue, 29 Jul 1997 08:54:07 -0400 |
Precedence: |
list |
Resent-From: |
|
Resent-Sender: |
|
X-Mailing-List: |
|
TO: |
|
Mime-version: |
1.0 |
Return-Path: |
<TechNet-request> |
X-Loop: |
|
From [log in to unmask] Thu Jul 31 11: |
44:20 1997 |
Resent-Message-ID: |
<"kHzv93.0.TkJ.sIUtp"@ipc> |
Content-type: |
text/plain; charset="us-ascii" |
Subject: |
|
From: |
|
Content-transfer-encoding: |
7bit |
Message-Id: |
|
X-Mailer: |
Microsoft Internet Mail & News for Macintosh - 3.0a (370) |
>From willli Tue Jul 29 07: |
40:40 1997 |
Parts/Attachments: |
|
|
Hello Colleagues
One of my favorite 'smaller-is-better' design Engineers found a Nanionics
connector which uses 30 AGW wire for thru-hole leads, and recommends a thru
hole diameter of 12-16 mils. (Tight tolerance, too, huh?)
Question: Has anyone had problems with soldermask being left in these small
holes. The alleged failure mode is from the LPI-developer not able to
develop out soldermask in these holes, due their small diameter. This is
reasonable, since LPI developing likes alot of impingement.
I am looking for individuals who can commiserate, and who may have worked
out an alternative.
Other topic we could also talk about is holding a +/- .002 hole size with
solder coating; HASL?; Plate and reflow?; Ni/ Immersion Gold?
Finally, who in the Board industry told Nanionics this was an 'easy' thing
to do? (just kidding)
George Franck
Raytheon E-Systems
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To subscribe/unsubscribe send a message <to: [log in to unmask]> *
* with <subject: subscribe/unsubscribe> and no text in the body. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|