[log in to unmask] wrote:
>
> Hello
>
> I would suspect a manfactuer's defect. These parts should
> be able to handle the thermals of a through-the-wave process.
> It should take the heat from IR as well. However, check your temps.
> When I decap is use BOE Glass etchant(a hydrophloric). A very
> nasty chemical. If you use it be careful. But it takes off the glass
> and preserves the silicon chip. The other best way for F/A would
> be a visual examination. Sometimes you can see the die attach.
> For visual: lightly sand the glass to get a flat end for viewing.
> then examing with your microscope 50 to 100X+ should do
> the trick.
> %&&&&&&&&&&&&&&&&&&&&&&&&&&&%
> Don F. Fumia
> [log in to unmask]
> Schneider Automation
> No. Andover MA
> %&&&&&&&&&&&&&&&&&&&&&&&&&&&%THANK YOU!
GABY