Wow!

Once again I'm amazed at the wealth of knowledge on the list.
Especially when I can use that painting spec on some new drawings.

I'd like to find a spec (mil or industry) for bending Al sheet - general
process guidelines and inspection.  I've got an Air Force Tech Manual but
citing those on drawings is frowned upon.

Hans

You can run . . .  but you'll only die tired.
~~~~~~~~~~~~~~~~~~~~~~~~~~~
Hans M. Hinners
Warner Robins Air Logistics Center (WR-ALC)
226 Cochran Street
Robins AFB, GA 31098-1622
Tele: (478) 926 - 5847 [DSN Prefix: 468]
Fax: (478) 926 - 4911
mailto:[log in to unmask]

---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------