Wow! Once again I'm amazed at the wealth of knowledge on the list. Especially when I can use that painting spec on some new drawings. I'd like to find a spec (mil or industry) for bending Al sheet - general process guidelines and inspection. I've got an Air Force Tech Manual but citing those on drawings is frowned upon. Hans You can run . . . but you'll only die tired. ~~~~~~~~~~~~~~~~~~~~~~~~~~~ Hans M. Hinners Warner Robins Air Logistics Center (WR-ALC) 226 Cochran Street Robins AFB, GA 31098-1622 Tele: (478) 926 - 5847 [DSN Prefix: 468] Fax: (478) 926 - 4911 mailto:[log in to unmask] --------------------------------------------------- Technet Mail List provided as a free service by IPC using LISTSERV 1.8e To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL) To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest Search the archives of previous posts at: http://listserv.ipc.org/archives Please visit IPC web site http://www.ipc.org/html/forum.htm for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 -----------------------------------------------------