Hi Rick,
I asked about this subject recently and got only a few replies, but was
advised to look at the TechNet archives and I found quite a bit there. Use
keywords like via, fill, plug, tent, etc.
Must say I didn't see much in the way of specs or standards though.
Good luck!
Tim Reeves
> ----------
> From:         Rick Babyak
> Sent:         Friday, March 31, 2000 4:46
> Subject:      via plugging
>
> Is there any acceptance criteria or a spec out there that covers via
> plugging with mask/ink?
>
>
>
> Rick Babyak
> Process Engineer
> Proto Circuit Inc.
> 7 Ascot Parkway
> Cuyahoga Falls, OH 44223
> 330-572-3401  Fax:330-572-3434
> [log in to unmask]
>

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################