I think the substrate itself is far more hygroscopic than either the mask or
the lettering ink.
Unless the inks aren't fully cured.
But to your point: It's quite possible to have a polymer mask and a UV
letter screen.
Or combinations including epoxy inks.
So out-gassing, if any, would not necessarily have to be the same for the
solder mask as for the silk screen.
But I'm curious: Why letter screen at-all?
- Are these boards being hand assembled?
- Is the lettering functional for repair purposes?
Most of the boards we fab today are so dense you can't even see the
post-assembly board. So unless you're hand-popping parts why risk ink-on-pads -- with
or without out-gassing?
Think I'll go tear some tags off of pillows...
ROBERT LAZZARA
VP, Business Development
T: (800) 560-9457
F: (800) 878-5566 (y servicio de mensaje espaņol)
E: [log in to unmask]
W:_ www.CircuitConnectUSA.com_ (http://www.circuitconnectusa.com/)
Circuit Connect, Inc.
ISO Certification : UL Listed : RoHS Exports : IPC Member : SMTA Member
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------