 
| Sender: |
|
| Subject: |
|
| From: |
|
| Date: |
Tue, 13 Oct 1998 14:42:43 +0200 |
| Content-Type: |
text/plain |
| MIME-Version: |
1.0 |
| Reply-To: |
|
| Parts/Attachments: |
|
|
> Hi Techies,
> we had following occurence with OSP-boards (Entek+) & throug hole
> components (THC):
> 1.reflow, then wave solder the THC: The THC have a nice solderjoint,
> which is not going throughout the hole. According to our design rules,
> this is a bad joint.
Is that singular for ENTEK?
This behaviour may prevent the usage of OSP, because the rules are somehow
holy.
> Any comments or suggestions?
>
> Wolfgang Nuechter
> Robert Bosch
> Germany
>
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|
