Another potential problem is the exposed copper edges.
----------
From: Steve Collins [SMTP:[log in to unmask]]
Sent: Friday, March 17, 2000 10:09 AM
To: [log in to unmask]
Subject: Re: [TN] v-scoring with perimeter copper on topside
I would not v-groove this board if you cannot get relief of the
copper on the
top from the edge of the board at least .030. Problem is you will
end up with a
burr on the edge of the board that can cause problems when you
separate boards.
Steve Collins
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV
1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for
additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################