Another potential problem is the exposed copper edges. ---------- From: Steve Collins [SMTP:[log in to unmask]] Sent: Friday, March 17, 2000 10:09 AM To: [log in to unmask] Subject: Re: [TN] v-scoring with perimeter copper on topside I would not v-groove this board if you cannot get relief of the copper on the top from the edge of the board at least .030. Problem is you will end up with a burr on the edge of the board that can cause problems when you separate boards. Steve Collins ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ############################################################## ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315 ##############################################################