Guys,
We are designing a very small board (.5" x 2") on an array. We think, we can
put it on an array with V-score for separation. Individual board has
perimeter copper on topside. It's a double sided board.  There is no
component in the vicinity of perimeter copper.

Knowing this, can I still go for v-score Or for V-grove, there should not be
copper in the cutting area ?

re,
ken patel

______________________________________________________
Ken Patel                       Phone:  (408) 490-6804
1708 McCarthy Blvd.             Fax:    (408) 490-6859
Milpitas, CA 95035              Beeper: (888) 769-1808

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
##############################################################