Jim, The thickness of HASL can be controlled to some degree. It depends on
conveyor speed, air pressure and air knife opening and angle. Board
configuration will also influence how much solder you're able to put on.

Hope this helps,

Mike Doty

-----Original Message-----
From: West, Jim [mailto:[log in to unmask]]
Sent: Tuesday, May 01, 2001 4:38 PM
To: [log in to unmask]
Subject: [TN] HASL can the height be controlled?


Hi,

Can the Height of HASL be controlled?  I have seen the process but don't
remember exactly where there are any control points.

Thanks,
Jim West

----------------------------------------------------------------------------
-----
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET
Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700
ext.5315
----------------------------------------------------------------------------
-----