Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 24 Apr 2002 15:15:28 -0400 |
Content-Type: | multipart/alternative |
Parts/Attachments: |
|
|
Mancorp does a good job in that area. They have a nice little Swiss made
tool by Essemtec.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]]On Behalf Of [log in to unmask]
Sent: Wednesday, April 24, 2002 11:26 AM
To: [log in to unmask]
Subject: [TN] Manual printing tables...
Hi All,
I'm looking for an inexpensive manual printing table to use for the
one'sies two'sies that we do here, and as a last ditch back-up when our DEK
goes down. I used one called a Palomar printing table when I was out in
California, and it did a really good job.
Could use any sized frame, nice precise hinge, had X/Y micrometers to fine
tune registration... could do 20-mil pitch all day long.
Are there any others out there?
-Steve Gregory-
|
|
|