We have a problem in our Hand Load Area - Not a big problem but a 
     problem. A lot of our assemblies use Hand Loaded - Through hole 
     Resistor Paks. We are constantly getting reversed Resnets (Human 
     error). My question is does anybody have a simple solution to solve 
     our little problem.
     
     * 1 Idea was to paint the polarity end to clearly show pin #1.
     
     * Another Idea was to place the R-Paks into foam before loading (this 
     idea would work but to time consuming).
     
     If anybody has any suggestions or Idea's I would greatly appreciate 
     it. Have a great day
     
     Sincerely. 
     ERic Bernal Process Engineer
     Pragmatech, Sunnyvale, Ca
     [log in to unmask]