 
| Mime-Version: |
1.0 |
| Content-Type: |
text/plain; charset=us-ascii |
| Date: |
Fri, 15 Jan 1999 18:01:55 -0500 |
| Reply-To: |
|
| Subject: |
|
| From: |
|
| Content-Transfer-Encoding: |
7bit |
| Organization: |
Applied CAD Knowledge Inc |
| Sender: |
|
| Parts/Attachments: |
|
|
.
'Netizens,
My question regards which flavor netlist to target? I've
not had any demand for -356A, but that means very little.
Is there application support for this (extended) flavor?
Any tools that use it? Require it?
Is -356A likely to have a short life, with GenCam and
that other flavor of vertical load looming?
Would fabricators care if they received "A" rather than
plain old 356?
Comments appreciated!
TIA and regards to all,
--
Jeff Seeger Applied CAD Knowledge Inc
Chief Technical Officer Tyngsboro, MA 01879
jseeger "at" appliedcad "dot" com 978 649 9800
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|
