Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 8 May 2002 10:14:39 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Technetters,
We're having a voiding problem on a 0.75 mm micro-BGA, the voids
size fluctuate from 15-40% of the pad area, we only have a 2D X-ray so there
is no way of determining the void size or the void location. IPC states that
is a process indicator if the voids stays within the 10-25% limit of the
solder ball to board interconnection. We're using a soak profile with a peak
temperature of 215-220 degrees, the soak extends for 110 seconds from
140-170, time above 183 is 60 secs and ramp rate stays below 1.5 C/sec. Is
there something we can do to eliminate or reduce the problem?, are voids a
real issue?
Any comments would greatly appreciated
Jorge Rodriguez
Process Engineer
Varian Electronics Manufacturing
615 South River Drive
Tempe, AZ 85281
[log in to unmask]
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|