From: Dennis J Fall@TFT on 04/20/99 03:06 PM
To: [log in to unmask]
cc:
Subject: Electrolytic plating on isolated areas or an alternative
I have been pulling my hair out trying to figure out how to electroplate
solder onto isolated areas (land pads, etc.). I have also been trying to
come up with other ways to do this (immersion, etc.). I basically need
about 5 ?m (0.2 mils) of solder. Does anyone have any great ideas???????
Thank You,
Dennis Fall P: 507-625-8445 x17
Engineer F: 507-625-3523
Thin Film Technology Corporation mailto:[log in to unmask]
1980 Commerce Drive http://www.thin-film.com
North Mankato, MN 56003-1702
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################