Subject: | |
From: | |
Reply To: | |
Date: | Mon, 24 May 1999 10:27:27 +1000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
While we're on the 20 mil subject ;
the same apply on the polyimide ? ; as they have better release ratio than
SS ?
Any comments on plastic stencils in general ?
Thanks paul
-----Original Message-----
From: Stephen R. Gregory [mailto:[log in to unmask]]
Sent: Saturday, 15 May 1999 2:04
To: [log in to unmask]
Subject: Re: [TN] Stencil Thickness
In a message dated 5/14/99 8:59:39 AM Pacific Daylight Time,
[log in to unmask] writes:
<< Hi Technetters,
What kind of stencil thickness you would recommend for 20 mil pitch QFP?
4, 5 or 6 mil ?
Thanks in advance.
Poh >>
Hi Poh!
I always get a 6-mil with the industry standard aperture reduction (20%
smaller)... always works for me without a problem.
-Steve Gregory-
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|