Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 11 Oct 2000 16:18:08 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Sorry all I miss-read George's question.
-----Original Message-----
From: George Gerberick [mailto:[log in to unmask]]
Sent: Wednesday, October 11, 2000 6:25 PM
To: [log in to unmask]
Subject: [TN] Copper measurement
We are looking for the least expensive way of measuring
total surface copper
thickness on a finished circuit board.
Typical areas would not be covered by soldermask but may
have white tin,
ni-au or solder. Equipment I have used in
the past was for copper in the hole, not surface. Any
suggestions?
----------------------------------------------------------------------------
-----
TechNet Mail List provided as a free service by IPC using
LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with
following text in
the BODY (NOT the subject field): SIGNOFF TECHNET
Please visit IPC web site
(http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or
847-509-9700 ext.5315
----------------------------------------------------------------------------
-----
---------------------------------------------------------------------------------
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF TECHNET
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------
|
|
|