Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Thu, 1 Apr 1999 16:25:11 -0600 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
I need to attach a J-leaded ASIC to one side of a ceramic board,
up-side-down, and a custom leadless ceramic part on the opposite side.
The spec for the leads of the ASIC package are: made out of Kovar or Alloy
42. All exposed metal and metallized area shall be gold plated with 60
micro-inches gold (min) over nickel plating.
We would like to attach this part using an solder alloy with a reflow temp
somewhat above that of 63/37, but below 280 C (lid attach temp), so we
won't unnecessarily reflow this part again when it is attached to it's main
board.
We have tried 96.5 Sn/3.5Ag (221 C eutectic) and are being killed with the
gold embrittlement/poisoning.
Any suggestions?
TIA
Charlie B.
281-552-3328 Voice
281-552-3100 FAX
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|