Subject: | |
From: | |
Reply To: | |
Date: | Mon, 19 Sep 2016 22:08:42 +0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Bev - As a previous owner of all 3 instruments , I can state that If I could buy only one, it would be a DSC.
> TMA too specific to CTE and somewhat more dependent on sample dimensions. Probes are pricey and susceptible to breakage.
> DMA too academic and esoteric . Hard to convince "non-techies" of what the data truly means.
> DSC somewhat of a more universal instrument suitable for both solder as well as polymer analyses.
As an FYI that you may already be aware of,... there is an IPC document which has a pretty good appendix briefly describing all 3 instruments, but alas I always forget which one. Hopefully some else will provide that bit of detail.
Rich Kraszewski
(920) 969-6075
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Bev Christian
Sent: Monday, September 19, 2016 4:05 PM
To: [log in to unmask]
Subject: [TN] Which would you chose?
TechNetters,
If you had the choice of getting ONE of:
1) TMA
2) DMA
3) DSC
And $ was not an issue, which would you chose and WHY? Please, no "it depends" answers and no, you can't throw TGA into the mix.
Regards,
Bev
|
|
|