Sender: |
|
X-To: |
|
Date: |
Wed, 28 Nov 2012 07:52:47 -0800 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
Message-ID: |
|
Content-Transfer-Encoding: |
quoted-printable |
Content-Type: |
text/plain; charset="utf-8" |
From: |
|
Parts/Attachments: |
|
|
Good morning.
I am trying to estimate the typical change in a solder ball's diameter
after reflow. IPC-7095B has great discussion about the typical change in
a ball's height after reflow but I did not see anything about
diametrical changes. Maybe there is another IPC document that addresses
this. Factors such as package weight, # of solder balls, ball alloy,
etc. influence collapse so I am sure there is no quick answer buy maybe
there is a rule of thumb to estimate the diametrical change.
Look forward to any advice. thx
Regards,
-Joe
"This e-mail and any attachments are solely for the use of the addressee and may contain L-3 proprietary information that may also be defined as U.S. Government export controlled technical data. If you are an unintended recipient of this e-mail, use, disclosure or distribution of its content is prohibited. Please notify the sender by return e-mail and immediately delete this message."
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|