Donna,
I have successfully used a 17 x 80 mil pad for QFPs. You can still fit
mask between the pads too!
Good luck.
Joe Reichert
>----------
>From: Donna Perry[SMTP:[log in to unmask]]
>Sent: Tuesday, September 30, 1997 1:24 PM
>To: [log in to unmask]
>Subject: [DESIGNERCOUNCIL] [DES]footprint TQFP144
>
>Hi
>I would appreciate pad geometry for a TQFP144. I do not find it in
>IPC-SM-782A.
>Thanks in advance for any assistance.
>Donna
>[log in to unmask]
>http:\\www.RadioConnect.com
>
>##############################################################
>IPC Designers Council Mail List provided as a free service by IPC using
>LISTSERV 1.8c
>##############################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
>text in the body:
>To subscribe: SUBSCRIBE DESIGNERCOUNCIL <your full name>
>To unsubscribe: SIGNOFF DESIGNERCOUNCIL
>##############################################################
>Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
>information.
>For the technical support contact Dmitriy Sklyar at [log in to unmask] or
>847-509-9700 ext.311
>##############################################################
>
##############################################################
IPC Designers Council Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DESIGNERCOUNCIL <your full name>
To unsubscribe: SIGNOFF DESIGNERCOUNCIL
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################