Donna, I have successfully used a 17 x 80 mil pad for QFPs. You can still fit mask between the pads too! Good luck. Joe Reichert >---------- >From: Donna Perry[SMTP:[log in to unmask]] >Sent: Tuesday, September 30, 1997 1:24 PM >To: [log in to unmask] >Subject: [DESIGNERCOUNCIL] [DES]footprint TQFP144 > >Hi >I would appreciate pad geometry for a TQFP144. I do not find it in >IPC-SM-782A. >Thanks in advance for any assistance. >Donna >[log in to unmask] >http:\\www.RadioConnect.com > >############################################################## >IPC Designers Council Mail List provided as a free service by IPC using >LISTSERV 1.8c >############################################################## >To subscribe/unsubscribe, send a message to [log in to unmask] with following >text in the body: >To subscribe: SUBSCRIBE DESIGNERCOUNCIL <your full name> >To unsubscribe: SIGNOFF DESIGNERCOUNCIL >############################################################## >Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional >information. >For the technical support contact Dmitriy Sklyar at [log in to unmask] or >847-509-9700 ext.311 >############################################################## > ############################################################## IPC Designers Council Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE DESIGNERCOUNCIL <your full name> To unsubscribe: SIGNOFF DESIGNERCOUNCIL ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ##############################################################