Any Philips CSM (Comet or Eclipse) who might be able to tell me what grease
fitting coupler they are using to grease the linear guides in these
machines?  The fitting is not a standard fitting that accepts a standard 3
or 4 sided locking coupler.  It is a small straight walled dome,
approximated 3.5mm in diameter.  The standard couplers we have can't seal
tightly over it, thus grease is not getting where it should be.

Philips technical support referred me to McMaster-Carr or Grainger, but I
can't find anything that would appear to work.  Am I missing something about
this fitting?  Any help appreciated.

Thanks.


Rick Thompson
Ventura Electronics Assembly
2665A Park Center Dr.
Simi Valley, CA 93065

+1 (805) 584-9858 voice
+1 (805) 584-1529 fax
[log in to unmask]

##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe:   SUBSCRIBE TECHNET <your full name>
To unsubscribe:   SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################