Any Philips CSM (Comet or Eclipse) who might be able to tell me what grease fitting coupler they are using to grease the linear guides in these machines? The fitting is not a standard fitting that accepts a standard 3 or 4 sided locking coupler. It is a small straight walled dome, approximated 3.5mm in diameter. The standard couplers we have can't seal tightly over it, thus grease is not getting where it should be. Philips technical support referred me to McMaster-Carr or Grainger, but I can't find anything that would appear to work. Am I missing something about this fitting? Any help appreciated. Thanks. Rick Thompson Ventura Electronics Assembly 2665A Park Center Dr. Simi Valley, CA 93065 +1 (805) 584-9858 voice +1 (805) 584-1529 fax [log in to unmask] ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or 847-509-9700 ext.5365 ##############################################################