Does anyone have any experience reworking through silicon conformal coating? We
have no problems today burning through with a soldering iron, HOWEVER we are
looking into a wave-type selective soldering peice of equipment. The concern is
contamination of the solder bath. Any experience out there on this?
thanks
Todd Vorpahl
[log in to unmask]
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################