Does anyone have any experience reworking through silicon conformal coating? We have no problems today burning through with a soldering iron, HOWEVER we are looking into a wave-type selective soldering peice of equipment. The concern is contamination of the solder bath. Any experience out there on this? thanks Todd Vorpahl [log in to unmask] ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################