Can someone explain the intricate differences between using the
Check > Schematic > With Defaults command from within Design
Architect and the Edit > Check Sheet command from the Session
window to check an entire schematic design?  Is this really just 2
methods of doing the same thing?  And, a follow-up question;
Are open sheets really skipped?

Thanks in advance.

Mike Huffman
PHILIPS Knoxville

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################