> From: Ken Bown [mailto:[log in to unmask]]
> Sent: Friday, September 18, 1998 12:10 PM
> To: [log in to unmask]
> Subject: pcb design rules
>
>
> LOOKING FOR DEESIGN RULES FOT PCB LAND SPACING VS VOLTAGE NEED TO APPLY 2KV
> BETWEEN LANDS AND CONNECTOR PINS.
> REGARDS, KEN BOWN
> DELTA V INSTRUMENTS
> RICHARDSON. TX
>
You can use the following guidelines:
0.00012 inch per volt for external layers
0.0001 inch per volt for internal layers
These are guidelines only! ZZZAP!
Tom Hybiske
General Atronics Corporation
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################