Soliciting suggestions on what to use for press pads that will not burn up
at temperatures 325 to 350 degrees C.  Possibilities are Teflon PFA
sandwiched between two layers of Kapton and/or steel wool pressure pads
manufactured by
FH Bonn Co.  Any other recommendations?  I'm wanting to laminate DuPont KJ
kapton to fragile ceramic plates.

_________________________________________________________________________
HIGH, JAMES W.                                      [log in to unmask]

    Mail Stop 390                 Microelectronics & Tech Support Section
    1 East Durand Street                             Fabrication Division
    NASA Langley Research Center                  Building 1238, Room 155
    Hampton, VA 23681-2199                          Phone    757-864-5416
                                                    FAX  757-864-8092

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################