Soliciting suggestions on what to use for press pads that will not burn up at temperatures 325 to 350 degrees C. Possibilities are Teflon PFA sandwiched between two layers of Kapton and/or steel wool pressure pads manufactured by FH Bonn Co. Any other recommendations? I'm wanting to laminate DuPont KJ kapton to fragile ceramic plates. _________________________________________________________________________ HIGH, JAMES W. [log in to unmask] Mail Stop 390 Microelectronics & Tech Support Section 1 East Durand Street Fabrication Division NASA Langley Research Center Building 1238, Room 155 Hampton, VA 23681-2199 Phone 757-864-5416 FAX 757-864-8092 ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################