Designers Council:

I am designing a board which has heavy current devices, required to handle
10A max peak.  The board will be constructed using 2 oz. copper.

IPC-D-275 5.3.2.3. states:

"Total cumulative copper web for all layers in any plated through hole
should not exceed .160" for 1 oz. copper, or .080" for for 2 oz. copper.

The total of the thermal relief cross sectional area divided by the number
of planes connected to the plated through hole, shall not violate current
carrying capacity requirements for a given hole.

If the individual web width violates the intended minimum conductor width
it shall be specified on the master drawing."

If I use the web width calculations, or even the .080" max web width for 2
oz copper, it's not going to handle the current without getting really hot.
 If I connect the hole directly into the plane, we'll have a difficult time
soldering it.

What is your recommendations and experience with this type of situation?

Thanks in advance for your advice and input.

David Baldwin
____________________________________

   PCB Designs by Baldwin Tech.
(602) 812-9246  FAX (602) 812-9247
   http://www.neta.com/~btech
____________________________________

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################