Sender: |
|
Date: |
Fri, 8 May 1998 15:39:50 +1000 |
Reply-To: |
|
Subject: |
|
MIME-Version: |
1.0 |
X-cc: |
|
Content-Transfer-Encoding: |
7bit |
Content-Type: |
text/plain; charset="us-ascii" |
From: |
|
Parts/Attachments: |
|
|
Dear fellows
While collecting a lot of boards from sub's around ; and prototypes ;
some of them have a bit to be desired for ;
and our Tech supp. manager hounds me for a decent rework rig .
The scenario is P&Place under production reflow profile simulation ;
convection both sides ; camera on monitor, and microslide .
The solder we'd feed with small xy dispenser on slide on other side ;
purchased separately .
The rig would double up as an evaluation preproduction and R&D tool due
to line being busy .
I have few ideas , but you have much more practice ; which is what
counts .
I would appreciate if you could share your views and help me to get this
one installed .
Any validational (reproducible) guidelines and comments of all sorts
most welcomed .
Directly routed advertising does have a high chance of sale ; please
quote , not via TechNet please ; some folks could have kittens .
Thank you all paul ; ResMed
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|