Dear fellows While collecting a lot of boards from sub's around ; and prototypes ; some of them have a bit to be desired for ; and our Tech supp. manager hounds me for a decent rework rig . The scenario is P&Place under production reflow profile simulation ; convection both sides ; camera on monitor, and microslide . The solder we'd feed with small xy dispenser on slide on other side ; purchased separately . The rig would double up as an evaluation preproduction and R&D tool due to line being busy . I have few ideas , but you have much more practice ; which is what counts . I would appreciate if you could share your views and help me to get this one installed . Any validational (reproducible) guidelines and comments of all sorts most welcomed . Directly routed advertising does have a high chance of sale ; please quote , not via TechNet please ; some folks could have kittens . Thank you all paul ; ResMed ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ################################################################