The artwork revision can never be higher than the drill drawing
revision since the drawing shows the artwork revisions.  The
drawing revision may be higher than the artwork revisions.

Another example:

I have released the initial drawing and artworks at revision A.  I
need to make a change that only effects layer 2.  My drawing will
go to revision B, stating that layer 2 is changed to revision B.
However, lets say I need to make a change only to the drill
drawing and not the artworks.  ( I need to modify the notes.)  The
drill drawing will change to revision C, layer 2 is still shown at
revision B, and all the other layers are still at revision A.

Hope this helps.
Larry

>>> Bruce C Rietdorf <[log in to unmask]> 05/26/98
10:52am >>>
Larry Campbell,

I understand your numbering scheme well. Very similar to ours.

Can you expand on what the revision level of the board is?

Do you mark the board revision to the highest artwork revision or
mark it
per the drill drawing revision?


_________________________________________________
Bruce Rietdorf
Raytheon Systems Company
1010 Production Road       M/S 10-61
Fort Wayne, IN  46808
Phone: 219 429-5150  Fax: 219 429-4774
e-mail:  [log in to unmask]

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC
using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to
[log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for
additional information.
For technical support contact Hugo Scaramuzza at
[log in to unmask] or 847-509-9700 ext.312
################################################################

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################