Hi all!
        I am trying to route a board that requires different width/spacing
     requirements for the edge connectors than the rest of the board.  The
     connectors have 254 pins total. Is there a way that I can define a
     class that will include all nets connected to this component without
     actually typing out all the net names?

           EG something in the lines of:
                        "define (class special allnets_J1)"

        Thanks for any assistance.


                Steve Sarasin
                [log in to unmask]

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################