Chris,

I am unfamiliar with that particular part. However, you should be ableo use
the IPC Land Pattern Calculator on the IPC web site (www.ipc.org). You must
link oover to the design section then over to the tools on the Designers
Council page.

You may find the part on the users database. If not, you will have to vreate
the part from scratch. Follow the instructions on the first page to get you to
a similar family of components. If you don't see one that is exact, pick one
that is close. Close meaning, it contains the quantity of dimensions you are
looking for. If you still can't find one, you may have to calcualte it in
pieces. The pieces should be assembled in opposing lead pairs.

The calculator will follow the principles outlined in the IPC-SM-782. The
variable inputs should be copied from similar existing component lead types.

Should you continue to have difficulties, please do not hesitate to contact me
offline.

Regards,

Gary Ferrari
Executive Director
IPC Designers Council

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################