Mime-Version: |
1.0 |
Sender: |
|
Subject: |
|
From: |
|
Date: |
Mon, 26 Jan 1998 06:31:46 -0500 |
Content-Type: |
text/plain; charset="us-ascii" |
Reply-To: |
|
Parts/Attachments: |
|
|
Andrea,
We have had great success using stock .062" thick PWB material as card
carriers. We also have more of a high-temp material that has proven to
withstand many reflow cycles. I even use our board router to fabricate the
carriers, which is a plus since I can fab everything in our department
cheaply. Then we put press-fit pins in to locate the boards. We normally use
this method to add extra support for board assemblies that are .020"-.035"
thick, but it could be utilized for your function. The obvious concern I
would have with 1\4" thick stock is all that mass effecting your reflow
profile...if you are running forced air convection, it is a little less of a
concern, but still going to effect your profile/reflow greatly. Feel free to
call me directly if I can answer specifics for you.
At 04:37 PM 1/23/98 -0500, you wrote:
>I would like some help on finding a good material for making card carriers
>to go through the reflow oven. We will be assembling a card with PTH
>connectors on both sides and will use the paste in hole process. The
>carrier would hold the bottomside connectors and support the board but
>cannot absorb too much heat to affect reflow. I have heard of ECP Plus
>from EMC and Delmat for making wave solder card carriers. Are those
>materials good for reflow as well? Is there anything better, less
>expensive, easier to machine, etc. out there? I would like to get the
>material in approximately 1/4" thick sheets and then have them milled out
>in our machine shop. You can e-mail me directly at [log in to unmask]
>
>Thanks for your input,
>Andrea Shurtz
>Lexmark Electronics
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe: SUBSCRIBE TechNet <your full name>
>To unsubscribe: SIGNOFF TechNet
>################################################################
>Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional
information.
>For the technical support contact Dmitriy Sklyar at [log in to unmask] or
847-509-9700 ext.311
>################################################################
>
>
>
----------------------------------
Jeff L. Hempton phone: (219) 429-7335 Fax: (219) 429-4688
Boardshop Manufacturing Engineer Mail Stop: 25-31
Raytheon Systems Company
1010 Production Road, Fort Wayne, IN 46808-4106
Email: [log in to unmask]
"The man who rolls up his sleeves seldom loses his shirt."--Thomas Cowan
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
################################################################
|
|
|