I am manufacturing boards to customer specification that have True
Position tolerancing on a connector pattern that must conform to ANSI
Y14.5M 1982.
A supplier in Australia is providing the raw board, and seems confused by
this type of tolerancing. They keep bringing up the fact that this
specification is an American National Standard.
I'm sure that there must be an International equivalency to this
standard.
Does anybody know what it is?
Thank You
Thank You,
Darrell Bonzo
EDO Corporation/Acoustic Division
Tele. 801-486-7481 Ext. 329
Fax 801-486-1447
E-Mail [log in to unmask]
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################