I am manufacturing boards to customer specification that have True Position tolerancing on a connector pattern that must conform to ANSI Y14.5M 1982. A supplier in Australia is providing the raw board, and seems confused by this type of tolerancing. They keep bringing up the fact that this specification is an American National Standard. I'm sure that there must be an International equivalency to this standard. Does anybody know what it is? Thank You Thank You, Darrell Bonzo EDO Corporation/Acoustic Division Tele. 801-486-7481 Ext. 329 Fax 801-486-1447 E-Mail [log in to unmask] ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311 ##############################################################