Subject: | |
From: | |
Date: | Thu, 10 Oct 96 13:26:49 EST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
We have separate geometries for those chip parts that are to be waved instead of
vapor phased. It has worked well.
______________________________ Reply Separator _________________________________
Subject: RE: ASSY: 0402 chip placement (#570929)
Author: [log in to unmask] at SMTPpost1
Date: 10/9/96 3:55 PM
You might discover an increase in tombstoning components attributed to the
amount of surface tension of the reflowed solder versus the relative weight
of the component. Often times one of the component pads may reflow a split
second prior to the other pad, and the resulting surface tensions may shift/
and or tilt the component up. These problems can be worked out by finding the
proper combination of reflow process, and component pad geometry. Some
manufacturers seem to use component pads that are reduced at the component ends
to help reduce the outward surface tension. Good luck.
Steve A
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|