 
| Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0vYaEc-0000YQC; Fri, 13 Dec 96 10:13 CST |
| Old-Return-Path: |
|
| Date: |
Fri, 13 Dec 96 07:40:49 PST |
| Precedence: |
list |
| Resent-From: |
|
| Resent-Sender: |
|
| X-Status: |
|
| Status: |
O |
| From [log in to unmask] Fri Dec 13 13: |
26:25 1996 |
| TO: |
|
| Return-Path: |
<TechNet-request> |
| Resent-Message-ID: |
<"6nzFS2.0.LPA.P2Oio"@ipc> |
| Subject: |
|
| From: |
|
| X-Loop: |
|
| X-Mailing-List: |
|
| Message-Id: |
|
| Parts/Attachments: |
|
|
A finger nail file works well......
Not too effiecient, but sometimes you gotta do what you gotta do!
______________________________ Reply Separator _________________________________
Subject: Gold finger burr
Author: [log in to unmask] at Internet
Date: 12/12/96 11:50 PM
Dear Technetter:
We have been having hard time with SIMM module card on a multiple array.
Normally, customer does not need edge bevelling for this array deisgn.
However, gold finger edge is always with some tiny loose burr which can not
be removed by routing . Is there any one knows what kind of tooling to
eliminate gold finger burr after routing without edge beveling ?
Thanks,
C.J. Long
Compeq Manufacturing, Co., LTD.
Email:[log in to unmask]
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|
