A finger nail file works well...... Not too effiecient, but sometimes you gotta do what you gotta do! ______________________________ Reply Separator _________________________________ Subject: Gold finger burr Author: [log in to unmask] at Internet Date: 12/12/96 11:50 PM Dear Technetter: We have been having hard time with SIMM module card on a multiple array. Normally, customer does not need edge bevelling for this array deisgn. However, gold finger edge is always with some tiny loose burr which can not be removed by routing . Is there any one knows what kind of tooling to eliminate gold finger burr after routing without edge beveling ? Thanks, C.J. Long Compeq Manufacturing, Co., LTD. Email:[log in to unmask] *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * *************************************************************************** *************************************************************************** * TechNet mail list is provided as a service by IPC using SmartList v3.05 * *************************************************************************** * To unsubscribe from this list at any time, send a message to: * * [log in to unmask] with <subject: unsubscribe> and no text. * *************************************************************************** * If you are having a problem with the IPC TechNet forum please contact * * Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] * ***************************************************************************