Subject: | |
From: | |
Date: | Tue, 05 Dec 95 14:42:11 EST |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
De: Denis Dionne
*** Renvoi de la note de 12/04/95 16:42
Non-classifi(c)e / Unclassified
Objet: ?
If you are talking about an Immersion Gold layer over Nickel I can
offer the following information:
Fine pitch and micro ball grid array devices require a flat and uniform
site for attachment, that can be acheived with electroless nickel and
immersion gold plating.
Some advantages of this type of plating is:
-uniformity of thickness
-long shelf life
-coating of electrically isolated features
-no flux required (but can be used)
-encapsulation of features
The predominant disadvantage is higher cost than other finishes.
As you mention, there is possibility of embrittlement with gold
finishes but it seems that testing as shown that a 3% gold weight
content should be respected to avoid such problems. This is shared
by several authors.
The immersion gold thickness should be thin enough so as to provide
adequate protection but not cause any embrittlement problem.
Two recent articles of interest to you would be:
Reflow soldering to gold, Electronic packaging and production
V 35 N 6 Jun 1995
Impact of PCB surface finish on SMT assembly process
National Electronic packaging & production conference v 2 1995 p 697-702
(good references...)
Please feel free to contact me for additionnal information.
Denis Dionne Ph: (514) 534-6724 Fax: (514) 534-7300
[log in to unmask]
|
|
|