Per your request, please see below:
***************************************************
David W. Bergman, Technical Director
IPC
2215 Sanders Road
Northbrook, IL  60062-6135
708-509-9700 x340 Phone
708-509-9798 Fax
email  [log in to unmask]
***************************************************


On Fri, 8 Dec 1995 [log in to unmask] wrote:

>      December 8, 1995
>      
>      I seem to remember some time back seeing an E-Mail on this forum 
>      regarding the cancellation of certain Mil Standards (Mil-Std 105 in 
>      particular) and then being replaced with ANSI standards. If anyone 
>      recalls this posting or can point me in the right direction to get the 
>      desired information, I would be most appreciative.
>      
>      Thanks in advance.
>      
>      Rich Paulauskas
>      VICOR Corporation
>      Andover, MA
>      
>      email:  [log in to unmask]
> 
> 
>From [log in to unmask] Sat Dec  9 14:42:46 1995
Date: Thu, 19 Oct 1995 15:23 CST
From: Nanci Baggett <[log in to unmask]>
To: [log in to unmask]
Subject: fwd: IPC & MIL-STD specs

I can reply on some of the specs you are concerned with.  The information I 
have was obtained from DESC back in June of this year.  Contact Desc and 
request an update to the status of what is referred to as "HOT 62".  This is a 
list of mil specs up for review to determine to keep, replace or delete.

Mil-Q-9858      Inactive for new design with changes to DFARS and cancel in     
            October 1996

Mil-STD-105     Cancelled by NOTICE 1 dated Feb. 27, 1995.  Future acquisitions 
                should refer to sampling procedures such as ANSI/ASQC Z1.4-1993

Mil-STD 45662   Canceled by NOTICE 2 dated Feb. 27, 1995.  Future acquisitions  
               should refer to ANSI/NCSL Z540-1, ISO 10012-1 or something       
          comparable. 

Hope this helps.
Nanci Baggett
Texas Instruments
[log in to unmask] 
-------------
Original Text
>From EMurphy @ SMTP (Ed Murphy) [log in to unmask], on 
10/18/95 03:11 PM:
To: technet @ SMTP (technet) [log in to unmask]

Hello all,

I am trying to find out if document numbers are still current.  If they

are not, would somebody please tell what the new numbers are or where 
I can find this information.
the document numbers are:

	MIL I 45208A (Inspection systems Requirements)

	MIL Q 9858    (Quality Program Requirements)

	MIL C 45662  (Calibration System Requirement)

	MIL-STD-883  (Test Methods & Procedures)

	MIL-STD-810  (Enviromental Test Methods)

	MIL-STD-105  (Sampling procedures and Tables for Inspection
		                   by attribute)

	IPC-ML-910A  (Printed Circuit Board Material)

	IPC-ML-950C  (Printed Circuit Board Performance)

Thank in advance
[log in to unmask]