Brock
Can you take a look at this and see if you have any suggestions for my
friends
On Wed, Aug 5, 2020 at 2:34 PM Robert Kondner <[log in to unmask]>
wrote:
> Larry,
>
> I kind of recall the MyData machines having a pressure profile for parts.
> It can generate a "Blow Off" pressure that should release the parts. I
> recall setting it too high can blow around small passives.
>
> Bob K.
>
> -----Original Message-----
> From: TechNet <[log in to unmask]> On Behalf Of Davis, Larry
> Sent: Tuesday, August 4, 2020 3:36 PM
> To: [log in to unmask]
> Subject: Re: [TN] Cree Blue LED (PN# CLM3A-BKW-CTBVA463) Sticking to
> Nozzle...
>
> Hi Steve,
>
> We are not running Mycronic machines but switching to a plastic nozzle did
> correct this issue for us.
>
> Good luck,
>
> LARRY DAVIS | PCBA Production Engineer
> P 970.663.1377 ext 2774
> Hach Company | www.hach.com | [log in to unmask]
>
>
> -----Original Message-----
> From: TechNet <[log in to unmask]> On Behalf Of Steve Gregory
> Sent: Tuesday, August 04, 2020 12:21 PM
> To: [log in to unmask]
> Subject: [TN] Cree Blue LED (PN# CLM3A-BKW-CTBVA463) Sticking to Nozzle...
>
> Hi All,
>
> We have these Cree Blue LED's (PN# CLM3A-BKW-CTBVA463) that keep sticking
> to the $%$#&@ pick and place nozzle. We have a MY-19 and have tried
> changing timing, nozzle diameters with no luck. We place an amber LED of
> the same series that we have no problems with except for one or two once in
> a while.
>
> I've tried dabbing a little Freecote mold release compound on the tip of
> the nozzle, and now I'm putting the reel into a 170F oven to see if baking
> them for a couple hours will help.
>
> Does anybody have any other ideas that might help?
>
> Steve Gregory
>
> --
> Steve Gregory
> Kimco Design and Manufacturing
> Process Engineer
> (208) 322-0500 Ext. -3133
>
> --
>
>
>
> This email and any attachments are only for use by the intended
> recipient(s) and may contain legally privileged, confidential,
> proprietary or otherwise private information. Any unauthorized use,
> reproduction, dissemination, distribution or other disclosure of the
> contents of this e-mail or its attachments is strictly prohibited. If you
> have received this email in error, please notify the sender immediately
> and delete the original.
> Please be advised that this email may contain confidential information. If
> you are not the intended recipient, please notify us by email by replying
> to the sender and delete this message. The sender disclaims that the
> content of this email constitutes an offer to enter into, or the acceptance
> of, any agreement; provided that the foregoing does not invalidate the
> binding effect of any digital or other electronic reproduction of a manual
> signature that is included in any attachment.
>
--
Jodi Sanchez
*Prototype Lead Engineering Technician*
*Cable Manufacturing *
[log in to unmask]
860 779.4339
Dayville CT USA
|