Hi Victor,
I shut my web page down over a year ago...
Steve Gregory
On Wed, Jan 22, 2020 at 11:14 AM <[log in to unmask]> wrote:
> Fellow Tech Netters,
>
> Perhaps it was too early in the morning for Rigid Flex PWBs questions.
> Therefore, I post the second time in hope that everyone is awake.
>
> I send some pics to Steve Gregory mail box.
>
> Victor,
>
> From: Hernandez, Victor G <[log in to unmask]>
> Sent: Wednesday, January 22, 2020 6:01 AM
> To: TechNet E-Mail Forum
> Cc: Hernandez, Victor G
> Subject: IPC-2223D, Sectional Design Standard for Flexible/Rigid-Flexible
> Printed Board
>
> Fellow Tech Netters,
>
> I would like a clarification on the above stated standard.
> Post Router Process:
>
> * How much PWB laminate material flashing is allowable exiting the
> rigid flex construction.
> * One side measures 5 mils and the other 25 mils.
> * No Strain Relief Fillet material utilized.
>
> Where can I upload pics?
>
> Victor,
>
--
Steve Gregory
Kimco Design and Manufacturing
Process Engineer
(208) 322-0500 Ext. -3133
--
This email and any attachments are only
for use by the intended
recipient(s) and may contain legally privileged,
confidential, proprietary
or otherwise private information. Any
unauthorized use, reproduction,
dissemination, distribution or other
disclosure of the contents of this
e-mail or its attachments is strictly
prohibited. If you have received
this email in error, please notify the
sender immediately and delete the
original.
|