Keystone has jumpers, but the closest to you is a replacement for a 1206
part (Keystone catalog #5108). The overhangs might be disagreeable to you,
but if centered I believe it would make IPC specs (no more than 25%
overhang).

Other than that, you can get custom leadframes made. There are purveyors of
SMT services who can complete the bending of these and put them into tape
for you. Not a good solution unless you are doing thousands.

Wayne Thayer

On Thu, Nov 8, 2018 at 10:58 AM Chris Thierolf <[log in to unmask]>
wrote:

> Has anyone replaced a SOD323 diode with a short? I found DC-12 jumpers
> from Topline that fit the package layout but they are a sole source
> supplier. Other than manually placing a wire on the pads, does anyone have
> a suggestion for placing a short on pads (dim = .102"pitch, .020width, .035
> pad length).
>
>
> Chris Thierolf
> Principal Engineer, EE
>
> L3 Power Distribution - SPD Electrical Systems
> 13500 Roosevelt Blvd.
> Philadelphia, PA 19116
> Ph. 215-698-6390
> [log in to unmask]<mailto:[log in to unmask]> / www.L3T.com<
> http://www.l3t.com/>
> [cid:[log in to unmask]]
> Confidentiality Notice
> This Electronic mail transmission is confidential, may be privileged and
> should be read or retained only by the intended recipient.  If you have
> received this transmission in error, please immediately notify the sender
> and delete it from your system.
>
>
> Beginning April 1, 2018, L3 Technologies, Inc. will discontinue the use of
> all @L-3Com.com email addresses. To ensure delivery of your messages to
> this recipient, please update your records to use [log in to unmask]
>